[runmeier]

My phone is nagging me with these messages all the time. When I finnish a call or receive one, I am told that Packet data (or whatever it is in English) is connected or disconnected.

I understand what it means, and why it's there - and I know that I can change the settings for Packet data. It's not about that. I just want to get rid of the messages. I do not want to see them.

Why? Because I have a Cisco VPN solution with callback and codes. So - when I pick up the call and enter the dialer - I have to wait for that stupid message to dissappear before I can start entering my pin. Which makes it even more difficult to hide when in meetings etc.

So - anyone? How do I turn of those messages?

[thescorpion]

can you tell us what is your phone model....
If it is S60 3rd then try this
go to settings..>connection..>packet data..>packet data connection..>when needed
try that and tell us what happend

[radical24]

yes i would be curious to know how to do it. it is higly annoying to have to wait for prompts to stop and then dial the rest of what you need to. it must be in some security or warning settings. i just can't figure out where and if at all it is possible. 

[runmeier]

As my avatar indicates, my phone is an N97, updated to the newest software. It means it is a S60-5 operating system.

I know that I can change Packet data access to when needed - it's not about that. I want the packet data access to be on whenever possible. I just want to get rid of the nagging messages. There are loads of similar messages that I would like to get rid of too - warnings that I do not need - like "forwarding active" etc. I do not like them - I know they are there to warn me, but I do not need the warnings - neither economically nor security-wise.:-)

[runmeier]

Is it so that no answer here means "not possible"?

I still want to get rid of the messages, it should be configurable, shouldn't it?